Plumbing referrals for Atlanta & nearby townsCall: (404) 637-2993
(404) 637-2993

Repiping in Union City, GA

plumberatlanta.net

From Union Street to the neighborhoods off Highway 138 and Shannon Parkway, call to be connected with a plumber who replaces worn water lines.

Meter spinning in Union City?
Call now to be connected with a local plumber in Union City.
(404) 637-2993

In Union City, repiping comes up for the older houses near Union Street and for homes where leaks past the meter keep returning. A plumber replaces the supply pipe on the customer's side of the city meter, all at once or by section. Call the number on this page to be connected with a local plumber in Union City.

New PEX supply lines run through open wall studs, repiping in Union City, GA

Are Union City homes old enough to need new supply pipe?

Some are. Union City's median home was built in 2002, but about 23% of housing predates 1980, under Census survey data. The city grew from a 1908 railroad town into a bedroom community, so the older houses near Union Street and Roosevelt Highway are the likeliest to have galvanized or early copper. Newer subdivisions toward South Fulton Parkway usually need a targeted repair instead.

If my meter keeps spinning, whose problem is it?

Yours. Union City's utility FAQ says that if the meter turns with every fixture off, the leak is on the customer's side, Public Works cannot work on private property, and a plumber has to make the repair. When those leaks keep coming back on the same old pipe, replacing the line from the meter, and sometimes the interior lines too, usually costs less over time than chasing each one.

What affects the cost of a repipe in Union City?

A plumber prices the job around:

  • The yard line: replacing the buried line from the meter at the same time adds digging but saves a second job later.
  • Foundation type: a crawl space gives open access underneath, while a slab pushes new lines up into walls and the attic.
  • Pipe material: copper costs more in labor because each joint is soldered, while PEX bends around corners with fewer fittings.
  • Permits and inspections: the permit office's required rough and final inspections are built into the schedule.
  • Patching after the work: some quotes include drywall patching and others stop at rough repair, so ask.
  • Wall and ceiling finishes: plaster, tile backsplashes and finished basement ceilings take more care to open and close.
  • Number of stories: a second floor or a bonus room over the garage lengthens runs and adds access points.
  • House size and fixture count: every bathroom, kitchen, laundry hookup and hose bib adds runs and fittings.
  • Phased or all at once: splitting the job into stages can spread the expense but repeats setup work.

Plumbing permits come from Union City Community Development through the city's online iWorQ portal.

Call now to be connected with a local plumber in Union City.
(404) 637-2993

Water source, briefly

Union City runs its own distribution system but buys treated Chattahoochee River water from the City of Atlanta through ten master meters, disinfected with chlorine. For anything about the water itself, the city's annual water quality report is the place to look.

Repiping questions in Union City

Is the pipe between the water meter and the house my responsibility?
Union City's FAQ says a meter that turns with everything off means a leak on the customer's side, which Public Works cannot repair on private property. That line is yours to have fixed by a plumber. That means a leak in the yard between the meter and the house is a job for your own plumber.
How can I tell what kind of supply pipe my house has?
Check wherever pipe is exposed: beside the water heater, under sinks, at the main shutoff or in the crawl space. Copper is reddish brown, galvanized steel is dull gray with threaded joints, polybutylene is gray plastic often stamped PB2110, and PEX is flexible red, blue or white tubing. With a median build year of 2002 in Union City, copper, CPVC and PEX are the materials you are most likely to find.
Can a plumber replace only the worst sections instead of the whole house?
Yes, when the trouble stays in one area, such as the hot-water side or a single bathroom group. If leaks keep turning up in different rooms, replacing one branch at a time often costs more than a single planned repipe. A plumber in Union City can price it both ways.
Should I choose PEX or copper for the new lines?
PEX is the more common pick for whole-house repipes because it is flexible and quicker to route. Copper costs more in labor but some owners prefer it where pipe shows. Either one is a big step up from failing galvanized or polybutylene.

More plumbing services in Union City

Repiping nearby

Call now to be connected with a local plumber in Union City.
(404) 637-2993

Last updated:

☎ Call (404) 637-2993